unhide recovery partition
ESXCLI

ESXCLI Basics: Configure Syslog Host

Another basic command, but essential for health monitoring of your hosts when using a Syslog Server. Here is a quick how-to. Connect to your host through SSH or open the DCUI. Setup the target Syslog Server and place logs in an unique subdirectory: # esxcli system syslog config set –logdir-unique true –loghost=udp://10.10.10.10:514 Open the ports for Syslog on the firewall: # esxcli network firewall ruleset set –e true –r syslog Apply the configuration with: # […]

unhide recovery partition
ESXCLI

ESXCLI Basics: Setup SNMP on ESXi 5.x

This is really basics stuff, but here is a quick how to. Connect to your host through SSH or open the DCUI. Setup the target SNMP server, port and community string: # esxcli system snmp set –t <ip_or_fqdn>@/<community_string> Enable SNMP: # esxcli system snmp set –e yes Logout. Done! 🙂 Verify the snmpd service is running and check if the ports are open on the host though vSphere Client or vSphere Web Client. Please note […]

ESXi 5

Upgrading ESXi 5.0 host to ESXi 5.1

In the last article I have covered the upgrade process from vCenter Server 5.0 to vCenter server 5.1. In this article I will cover a quick how to on upgrading your ESXi host to version 5.1. In this case, I will perform an in place upgrade of the host. Before you proceed with upgrade in your production environment, please read chapter 6 “Upgrading and Migrating Your Hosts” from the vSphere Upgrade guide. Boot your server […]